Toro GreensPro 1240, Руководство по обслуживанию

Страница: 131 / 186

Adjustments
Adjusting the Steering Linkage
CAUTION
Use a suitable lifting device to safely raise and support the machine
to access the components under the chassis.
1. Insert a block between the steering pivot assembly and chassis to prevent
the steering pivot assembly from moving during adjustment, and to position
steering pivot assembly square with the chassis (
Figure 53 ). Block should be
approximately 19 mm (0.75 inch) thick.
g240025
Figure 53
GreensPro 1240 shown
1. Chassis frame 3. Steering pivot assembly
2. Block
2. For GreensPro 1240:
Note: Each steering linkage rod includes 2 ball joints and 2 hex nuts. To
allow adjustment, 1 ball joint and 1 hex nut has left-hand threads, and
1 ball joint and 1 hex nut has right-hand threads. Before attempting to
loosen the hex nuts for linkage adjustment, inspect the threads on the
linkage rod to determine the thread direction.
A. Loosen the hex nuts and turn the steering pivot rod until the steering
head linkage arm ball joints (on steering disc) are aligned front to back
(
Figure 54 ). Do not tighten the steering pivot rod hex nuts at this time.
GreensPro ™ 1240/1260 Page 7–5 Chassis: Adjustments
14211SL Rev A