6
Installing the Wire Harness
and Throttle Cable
Parts needed for this procedure:
1
Wire harness
1
Engine switch
4
Cable ties
1
Throttle cable
1
Cable clip
1
Console cover
Procedure
1.
Install the wire harness to the interlock connector
on the wire harness bracket and clip the wire
harness to the bracket (
).
g274613
Figure 13
1.
Wire harness connectors
3.
Interlock connector
2.
Install the wire harness
clip here.
2.
Mount the green ground wire using the cowling
bolt under the fuel tank, and connect the red wire
to the engine connector as shown in
Note:
Apply skin-over grease to the bolt and
ground lug terminal.
g274609
Figure 14
1.
Cowling bolt
4.
Engine connector
2.
Ground wire
5.
Install this wire harness
connector to the engine
connector.
3.
Disconnect this wire from
the engine connector.
3.
Route the harness up the left side of the handle
(
).
4.
Install the engine switch in the console and
connect it to the wire harness (
Note:
Connect the wire harness to the
hourmeter (if equipped).
5.
Secure the wire harness under the console
cover with a snap clip and cable ties as needed.
6.
If the machine has a light kit, use the wire
harness adapter to install the main wire harness
to the engine.
7.
Attach the cables and wire harness to the
handles using the 4 new cable-ties (
).
11