About (cont'd.)
B
ATTERY
Lists the software part number
and the revision version for
the battery.
CAN B
US
Lists the machine
communication bus status.
T
RACTION
3
Lists the software part number
and the revision version for
the 3-Wheel Drive Kit (if
equipped).
Note:
Protected under Protected
Menus—accessible only by entering PIN;
refer to
Accessing Protected Menus (page 20)
.
Accessing Protected Menus
Note:
The factory default PIN code for you machine
is either 0000 or 1234.
If you changed the PIN code and forgot the code,
contact your authorized Toro distributor for assistance.
1.
From the M
AIN
M
ENU
, use the center button to
scroll down to the S
ETTINGS
M
ENU
and press the
right button.
2.
In the S
ETTINGS
M
ENU
, use the center button to
scroll down to the P
ROTECTED
M
ENU
and press
the right button.
3.
To enter the PIN code, press the center button
until the correct first digit appears, then press
the right button to move on to the next digit.
Repeat this step until the last digit is entered and
press the right button once more.
4.
Press the middle button to enter the PIN code.
Wait until the red indicator light of the InfoCenter
illuminates.
Note:
If the InfoCenter accepts the PIN code
and the protected menu is unlocked, the word
“PIN” displays in the upper right corner of the
screen.
You have the ability to view and change the settings in
the Protected Menu. Once you access the Protected
Menu, scroll down to the Protect Settings option. Use
the right button to change the setting.
•
Setting the Protect Settings to O
FF
allows you to
view and change the settings in the Protected
Menu and view the CU motor and traction
information screens without entering the PIN code.
•
Setting the Protect Settings to O
N
hides the
protected options and requires you to enter the PIN
code to change the setting in the Protected Menu.
After you set the PIN code, rotate the key switch to
the O
FF
position and back to the O
N
position to enable
and save this feature.
Note:
Rotate the key switch to the O
FF
position and
then to the O
N
position to lock the protected menu.
Setting the Machine Configuration Passcode
You can set a passcode on the InfoCenter so that an
operator cannot access specific InfoCenter screens
without it. Refer to
Menu Items (page 18)
for the InfoCenter screens that
are passcode-protected.
1.
From the S
ETTINGS
menu, select P
ROTECT
S
ETTINGS
.
2.
Set P
ROTECT
S
ETTINGS
to O
N
.
3.
When prompted, enter a 4-digit passcode.
4.
Turn the ignition key to the O
FF
position to save
the code.
Note:
If you forget the user defined passcode,
you can obtain a temporary passcode from your
authorized Toro distributor.
Understanding the Fault-Log Indicator
If a fault occurs, a fault code appears on the
InfoCenter screen and a red flashing light appears
above the screen.
The fault is stored in a log entry located in the F
AULTS
menu, which you or your distributor can use to identify
the issue that prompted the fault.
For a list of faults, refer to the
Service Manual
or your
authorized Toro distributor.
Main-Power Connectors
Before you charge the machine, work on the machine,
or install, remove, or work on the cutting units,
disconnect the machine from the power supply by
separating the main-power connectors (
located at the base of the roll bar on the left side of
the traction unit. Plug the connectors together before
operating the machine.
20
