Toro Greensmaster eTriFlex 04590, Руководство оператора

Страница: 15 / 56

Controls
g267033
Figure 16
1. Function-control switch 3. InfoCenter
2. Lift/lower joystick 4. Key switch
Key Switch
The key switch has 2 positions: O
N
and O
FF
( Figure
17 ).
Use the key switch to turn on or shut off the machine;
refer to
Turning On the Machine (page 27) and
Shutting Off the Machine (page 30) .
g292048
Figure 17
1. O
N
2. O
FF
Function-Control Switch
The function-control switch ( Figure 16 ) provides 2
traction selections plus a N
EUTRAL
position.
•
N
EUTRAL
position—neutral and backlapping
•
M
OW
position—used for mowing operation
•
T
RANSPORT
position—used for transport operation
You can shift from M
OW
to T
RANSPORT
or T
RANSPORT
to M
OW
(not to N
EUTRAL
) while the machine is in
motion; no damage will result
You can move the switch from T
RANSPORT
or M
OW
to N
EUTRAL
and the machine will come to a stop. If
you try to switch from N
EUTRAL
to M
OW
or T
RANSPORT
while the pedal is not in the N
EUTRAL
position, an
advisory occurs.
Lift/Lower Joystick
The lift/lower joystick ( Figure 16 ) raises or lowers
the cutting units. The joystick can engage or
disengage the cutting-unit reels, depending on the
function-control-switch position:
•
Function-control switch in the N
EUTRAL
position : The cutting units will raise or lower as
long as you move the joystick forward or backward,
but the reels will not engage unless the machine is
in Backlap Mode.
•
Function-control switch in the M
OW
position :
Move the joystick forward during your cutting
operation to lower the cutting units and start the
reels. Pull back on the joystick to stop the reels
and raise the cutting units.
To stop the reels without raising the cutting units,
pull back on the joystick momentarily and release
it. Moving the joystick forward again will start the
reels or pulling back again will lift the cutting units.
You must engage this feature in the InfoCenter;
refer to
Adjusting the Tap-Off Delay (page 23) .
•
Function-control switch in the T
RANSPORT
position : The cutting units can be raised, but the
reels will not engage. An advisory appears in the
InfoCenter if you attempt to lower the cutting units.
Traction Pedal
The traction pedal ( Figure 18 ) has 3 functions: to
make the machine move forward, to move it backward,
and to stop the machine. Press the top of the pedal to
move forward; press the bottom to move backward or
to assist in stopping when moving forward.
To stop the machine, allow the pedal to move to the
N
EUTRAL
position. Do not rest the heel of your foot on
the traction pedal in the R
EVERSE
position while the
machine is moving forward ( Figure 19 ).
15