Toro Greensmaster eFlex 1800, Руководство по обслуживанию

Страница: 70 / 312

Removing the Traction Drum (continued)
3. If installed, remove the rail kit wheels; refer to Rail Kit Wheels (Optional)
(page 6–24) .
4. Remove the handle assembly from the machine; refer to Handle Assembly
(page 6–4) .
5. Support both sides of the machine frame with the jack stands or suitable
blocking to prevent the machine from moving.
g204320
Figure 34
1. Kickstand 7. Left side plate
2. Handle clamp 8. Carriage screw
3. Offset handle clamp 9. Frame
4. Counterweight 10. Flange nut
5. Flange-head screw (3 each) 11. Rear frame
6. Hardened washer (4 each)
6. Separate the left side plate from the machine ( Figure 34 ) as follows:
A. Remove the flange nut, hardened washer, and carriage screw (items 10,
6, and 8 in Figure 34 ) that secure the left side plate to the rear frame.
B. Remove the 3 flange-head screws and 3 hardened washers (items 5 and
6 in Figure 34 ) that secure the left side plate to the frame.
C. Slide the left side plate from supporting bearing and remove from the
machine.
7. Insert a bar stock or other suitable tool through the spokes of the left traction
drum to keep the drum from turning.
8. While retaining the left drum, loosen and remove the bearing nut (item 26 in
Figure 33 ) from the traction drum assembly. The ball bearing is pressed onto
the bearing nut so it can be removed with the nut.
9. Slide the left traction drum (item 27 in Figure 33 ) from the drum shaft. Locate
and retrieve the square key from the shaft.
10. If necessary, carefully remove the grease seal (item 28 in Figure 33 ) from
the left traction drum, ensure that you do not damage the bore of the drum.
Discard the seal that was removed.
Traction and Reel Drive System: Service and Repairs Page 4–28 Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E