Toro Greensmaster 3120, Руководство оператора, Страница: 11 / 48

3
Installing the Roll Bar
Parts needed for this procedure:
2
Bolt (1/2 x 1-3/4 inches)
6 Bolt (1/2 x 1-1/2 inches)
8 Nut (1/2 inch)
Procedure
1. Remove the screws and nuts supporting the
jack pad on the right side of the machine.
2. Lower the roll bar ( Figure 6 ) onto the mounting
brackets, aligning the mounting holes.
g213342
Figure 6
1. Jack pad 4. Roll bar
2. Bolt (1/2 x 1-3/4 inches) 5. Seat belt
3. Bolt (1/2 x 1-1/2 inches)
3. Secure the left side of the roll bar to the mounting
bracket with 4 bolts (1/2 x 1-1/2 inches) and
locknuts (
Figure 6 ).
4. Torque the fasteners to 91 to 115 N∙m (67 to 85
ft-lb).
5. Secure the right side of the roll bar and the
previously removed jack pad to the mounting
bracket with 2 bolts (1/2 x 1-1/2 inches), 2 bolts
(1/2 x 1-3/4 inches), and locknuts as illustrated
in
Figure 6 .
6. Torque the fasteners to 91 to 115 N∙m (67 to 85
ft-lb).
WARNING
Failure to wear the seat belt while operating
the vehicle can result in you being thrown
from the seat and injured during a rollover
accident.
Always use the seat belt.
4
Installing the Cutting Units
For Cutting Unit Models 04610,
04611, 04616, 04618, 04619, 04624,
04652, 04654, and 04656
Parts needed for this procedure:
3
Cutting unit (obtain from your authorized Toro
distributor)
3 Grass basket
Procedure
CAUTION
The blades are sharp and can cut your hands.
Wear heavy leather or cut-resistant gloves
when handling the cutting units.
Important:
Do not raise the suspension to the
transport position when the reel motors are in the
holders on the machine frame. Damage to the
motors or hoses could result.
Note:
When sharpening, setting the height of cut,
or performing other maintenance procedures on the
cutting units, store the cutting unit reel motors in the
support tubes on the front of the frame and side of the
machine to prevent damaging the hoses.
1. Remove the cutting units from the cartons.
Assemble and adjust them as listed in the cutting
unit
Operator's Manual .
2. Slide the cutting unit under the pull frame while
sliding the lift hook onto the lift arm (
Figure 7 ).
11