Toro Greensmaster 1018, Руководство по установке

Страница: 4 / 20

6. Remove the cap and to expose the bearing nut
(
Figure 3 ).
7. Remove the bearing nut from the reel shaft
(
Figure 3 ).
Important:
Clean the threads in the end of
the reel shaft of any debris or grease before
installing the splined insert and groomer box
from this kit.
3
Removing the Reel-Drive
Assembly
No Parts Required
Procedure
1. Remove the hardware that secures the reel-drive
assembly to the side plate (
Figure 4 ).
g287976
Figure 4
1. Socket-head screw 4. Spring washer
2. Spacer 5. O-ring
3. Washer 6. Nut
2. Remove the reel-drive assembly, flat washers,
spring washers, spacers, and O-rings from the
side plate (
Figure 4 ).
4
Installing the Groomer
Drive Box
Parts needed for this procedure:
1 Reel adapter
1 Shim washer
1
Groomer drive box
Procedure
1. Apply medium-strength, thread-locking
compound (such as Blue Loctite® 243) to the
internal threads of the drive-box shaft and torque
the reel adapter and groomer drive-box shaft to
150 to 163 N∙m (110 to 120 ft-lb).
g283538
Figure 5
1. Groomer drive-box shaft
2. Reel adapter
Important:
Allow the thread-locking
compound to cure for 15 minutes before
continuing the procedure.
Note:
When torquing the reel adapter and
drive-box shaft, restrain the drive-box shaft with
a wrench on the wrench flats at the inboard side
of the groomer drive box (
Figure 6 ).
4