Toro Greensmaster 1018, Руководство по установке

Страница: 13 / 20

Transporting the Machine
When you wish to mow without the groomer or need
to transport the machine, move the quick-up lever to
the T
RANSPORT
position ( Figure 21 ).
Note:
This moves the groomer reel into a raised
position.
g287375
Figure 21
1. T
RANSPORT
position 2. O
PERATION
position
Maintenance
Changing the Gearbox
Lubricant
Service Interval:
•
After the first 100 hours
•
Every 500 hours/yearly (whichever comes first)
1. Clean the external surfaces of the groomer
housing.
Important:
Ensure that there is no dirt or
clippings on the outside of the groomer
housing; if debris gets inside of the groomer
it can damage the gearbox.
2. Remove the drain plug on the bottom of the
housing (
Figure 22 ).
g286955
Figure 22
1. Air-vent plug 3. Drain plug
2. Fill plug
3. Remove the fill plug on the side of the housing
and loosen the air vent plug on the top so air
can pass through (
Figure 22 ).
4. Align a suitable container beneath the oil drain
port to catch drained oil.
5. Tip the cutting unit (as shown in Figure 23 )
until the drain port is at the bottom to ensure
complete drainage.
6. Slowly rock the cutting unit back and forth to
ensure that the oil has completely drained from
the housing. When the oil is completely drained,
place the cutting unit on a level surface as
shown in
Figure 24 .
13