Toro Greensmaster 1018, Руководство по установке

Страница: 11 / 20

Adjusting the Groomer
Height
Important:
Never set the groomer lower that 1/2
the height of the cut—up to 13 mm (0.5 inch); you
can make adjustments 0 to 6 mm (0 to 0.25 inch)
below the height of cut thereafter.
Important:
If you set the groomer higher that the
height of cut, inadvertent groomer contact with
the basket may occur when using the
QUICK
-
UP
POSITION
. Never set the groomer higher than the
height of cut in the
OPERATING
position.
1. Park the machine on a level surface, engage the
parking brake, and shut off the engine.
2. Set the cutting-unit height of cut; refer to your
cutting unit
Operator’s Manual .
3. Raise or lower the grooming reel as follows:
A. Ensure that the the quick-up levers ( Figure
19 ) are in the O
PERATION
position (i.e., the
lever points toward the front of the cutting
unit).
B. At the end of the groomer reel, measure the
distance from the lowest tip of the groomer
blade to the working surface (
Figure 19 ).
Turn the height-adjuster knob ( Figure 19 ) to
raise or lower the tip of the groomer blade
to the desired height.
C. Repeat step B on the opposite end of the
groomer, then check the setting on the first
side of the groomer. The measured height
at each end of the groomer reel must be
identical. If the measured height at each
end of the groomer is different, rotate the
adjuster knob(s) until they are identical.
g283316
Figure 19
1. Height-adjuster knob 3. Groomer height (HOG)
2. Quick-up lever (shown in
the O
PERATION
position)
11