Toro Greenmaster 1000, Руководство по обслуживанию

Страница: 87 / 140

Greensmaster 1000/1600
Page 6 – 5
Wheels and Accessories
Removal
1. Park mower on a level surface. Make sure engine
is OFF.
2. Cut cable ties from the handle.
3. Remove cap screw (30), spring lock washer (31),
and flat washer (32) from each handle pivot pin (33) on
each of the handle (35) ends (Fig. 2 and 3).
Note: The cotter pin, ring pin, cap screw,and lock nut
may have to be removed from the handle arms to allow
handle removal (Fig. 4).
4. Squeeze handle ends inward. Remove handle ends
from the handle pivot pins; pull handle ends clear of the
holes in the handle arms (Fig. 3).
Installation
Note: The cotter pin, ring pin, cap screw,and lock nut
may have to be removed from the handle arms to allow
handle installation (Fig. 4).
1. Slide handle ends through the holes in the handle
arms. Squeeze handle ends inward. Install handle ends
to the handle pivot pins (33) on each side of the frame.
(Fig. 2 and 3).
2. If the cotter pin, ring pin, cap screw,and lock nut
have been removed from the handle arms, reinstall the
handle arms to the frame. Make sure spacer is installed
in the handle arm. (Fig. 4).
3. Install cap screw (30), spring lock washer (31), and
flat washer (32) to each handle pivot pin (33) on each of
the handle (35) ends (Fig. 2 and 3).
4. Secure cables to the handle with new cable ties.
1. Cap screw & washers
2. Handle
end
3. Cotter pin
4. Ring pin
5. Lock nut
6. Handle arm
Figure 3
1
2
6
5
4
3
1. Cotter pin
2. Ring pin
3. Cap screw
4. Lock nut
5. Handle arm
6. Spacer
Figure 4
5
1
3
6
4
2
Wheels and
Accessories