Toro GrandStand TURBO FORCE 74513, Руководство оператора

Страница: 53 / 60

Adjusting the Deck-Lift
Spring
Note:
Adjusting the compression spring alters how
much the deck floats and the amount of effort needed
to lift the deck when using the height-of-cut lever.
•
More spring compression reduces the lever lift
force required and causes the deck to float more.
•
Less spring compression increases the lever lift
force required and causes the deck to float less.
1. Raise the height-of-cut lever and lock it into the
transport position.
2. Check the distance between the spring nut
and the rear side of the welded mount bracket
(
Figure 84 ).
3. Ensure that the length is between 47 to 50 mm
(1.8 to 2 inches) (
Figure 84 ).
4. If needed, adjust the distance by adjusting the
bolt on the front of the mount bracket (
Figure 84 ).
g031566
Figure 84
1. Deck-lift spring 4. Adjustment bolt
2. Spring nut
5. Length is between 47 to
50 mm (1.8 to 2 inches).
3. Rear side of the mount
bracket
5. Repeat this procedure for the opposite deck-lift
spring.
Replacing the Grass
Deflector
WARNING
An uncovered discharge opening could allow
the machine to throw objects toward you or
bystanders, resulting in serious injury. Also,
contact with the blade could occur.
Do not operate the machine unless you install
a cover plate, a mulch plate, grass deflector,
or bagger.
1. Remove the locknut, bolt, spring, and spacer
holding the deflector to the pivot brackets
(
Figure 85 ).
g015594
Figure 85
1. Bolt 5. Spring (installed)
2. Spacer 6. Grass deflector
3. Locknut 7. J -hook end of the spring
4. Spring
2. Remove the damaged or worn grass deflector.
3. Place the spacer and the spring onto the grass
deflector.
4. Place 1 J -hook end of the spring behind the
deck edge.
Note:
Make sure that 1 J -hook end of spring is
installed behind deck edge before installing the
bolt as shown in
Figure 85 .
5. Install the bolt and the nut.
6. Place 1 J -hook end of the spring around the
grass deflector ( Figure 85 ).
Important:
The grass deflector must be able
to rotate. Lift the deflector up to the full open
position, and ensure that it rotates into the
full-down position.
53