Toro GrandStand TURBO FORCE 74513, Руководство оператора

Страница: 52 / 60

g031519
Figure 82
1. Top bolt 4. Side nut
2. Jam nut 5. Adjust these yokes to
adjust the front side of the
mower deck.
3. Yoke 6. Adjust these yokes to
adjust the rear side of the
mower deck.
2. Rotate the top bolt of the yokes to adjust the
height of the mower deck (
Figure 82 ).
Note:
Rotate the bolt clockwise to raise the
deck; rotate the bolt counterclockwise to lower it.
3. Tighten the jam nuts and side bolts.
4. Check the front-to-rear pitch; refer to Checking
the Mower Deck Front-to-Rear Pitch (page 51) .
Matching the Height-of-Cut
1. Check the rear tire pressure.
2. Set the height-of-cut to the 7.6 cm (3 inches)
position; refer to
Adjusting the Height-of-Cut
(page 20) .
3. With the machine on level surface, position 1
blade front-to-rear.
4. Measure at A , and from a level surface to the
cutting edge of the blade tips ( Figure 83 ).
Note:
The measurement should be 7.6 cm (3
inches).
g000975
Figure 83
1. Measure from a level
surface 2. Measure the blade at point
A
5. If the measurement is not correct, locate the
front 2 yokes on the machine (
Figure 82 ).
6. Loosen the side bolt and jam nut of the yokes.
7. Adjust the top bolt of the yokes until the blade
tips match 7.6 cm (3 inches).
8. Tighten the jam nuts and side bolts.
52