Toro Grandstand 78524, Руководство оператора

Страница: 7 / 24

1
Preparing the Machine
No Parts Required
Procedure
Note:
Remove the Roller Striper Kit, if installed, prior
to installing this attachment.
1. Disengage the PTO, move the motion-control
levers to the N
EUTRAL
-
LOCK
position, and
engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Repair all bent or damaged areas of mower
deck and replace any missing parts.
4. Clean the machine of any debris on the deck or
rear part of the machine to ease installation.
2
Installing the E-Z Vac
Blower and Drive Kit
Parts needed for this procedure:
1 E-Z Vac Blower and Drive Kit (sold separately)
Procedure
Refer to the Installation Instructions for the kit.
3
Installing the Blower
Assembly, Belt, and Belt
Cover
Parts needed for this procedure:
1 Blower assembly (from the Blower and Drive Kit)
1 Belt (from the Blower and Drive Kit)
1
Belt cover (from the Blower and Drive Kit)
1 Knob (from the Blower and Drive Kit)
Procedure
1. Lower the mower deck to the lowest setting.
2. Insert the pin from the blower assembly into the
blower mount bracket as shown in
Figure 4 . Do
not latch the blower on the blower mount.
g274289
Figure 4
1. Blower assembly 3. Insert the pin here.
2. Pin
3. Install the belt to the pulleys and idler assembly
as shown in
Figure 5 and Figure 6 .
7