into the V-groove of the blower pulley. Hold the
belt taut and rotate the pulley slowly by hand.
decal138-8866
Figure 27
9.
Close the blower assembly so that the handle
latches.
10.
Install the belt cover.
Inspecting the Bagger
Service Interval:
Every 100 hours
After the first 8 hours
1.
Disengage the PTO, move the motion-control
levers to the N
EUTRAL
-
LOCK
position, and
engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Check the upper tube, lower tube, bagger hood,
and the blower assembly. Replace these parts if
they are cracked or broken.
4.
Check the bags, bagger frame, and screen.
Replace any parts that are cracked or broken.
5.
Tighten all nuts, bolts, and screws.
Inspecting the Mower
Blades
1.
Inspect the mower blades regularly and
whenever a blade strikes a foreign object.
2.
If blades are badly worn or damaged, install new
blades. Refer to the
Operator's Manual
for the
machine for complete blade maintenance.
Installing the Mower Blades
In most mowing conditions, the standard high-lift
blades provide the best bagging performance.
Use a Toro Atomic blade for bagging leaves in dry
conditions. In dry dusty conditions, the medium lift
or low lift blades reduce dust and dirt blowout while
providing effective bagging air flow.
Contact an Authorized Service Dealer for the proper
blades for different mowing conditions.
Refer to the machine
Operator's Manual
for more
information on installing blades.
20
Содержание Grandstand 78524
Страница 23: ...Notes...
