Toro GrandStand 74583, Руководство оператора

Страница: 46 / 68

Brake Maintenance
Servicing the Brake
Before each use, check brakes on both a level surface
and slope.
Always set the parking brake when you stop the machine
or leave it unattended. If the parking brake does not
hold securely, an adjustment is required.
Checking the Parking Brake
Service Interval: Before each use or daily
1. Park the machine on a level surface, disengage the
PTO.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Release the brake. The brake bars should lift off
the tires and the hand lever should travel forward to
the end of the slot in the control panel. Adjust the
brake if needed.
4. Engage the brake lever until the brake bars first
contact the tire (Figure 70).
5. Measure the gap from the front of the hand lever
to the end of the slot in the control panel when the
brake bar contacts the tire. This measurement needs
to be 3/4 inch (19 mm). Adjust the brake if needed
(Figure 70).
1
2
3
4
5
6
g017742
BJG
Figure 70
1. Hand lever 4. Front of slot
2. Front of hand lever 5. Brake bar
3. 3/4 inch (19 mm) gap 6. Brake bar just touching
the tire
Adjusting the Brakes
If the parking brake does not hold securely, an
adjustment is required.
1. Check the brake before you adjust it; refer to
Checking the Brakes.
2. Park the machine on a level surface, disengage the
PTO, and set the parking brake.
3. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
4. Release the parking brake; refer to Releasing the
Parking Brake Operation.
46