Toro GrandStand 74583, Руководство оператора

Страница: 24 / 68

Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1. Disengage the blade control switch (PTO), move
the motion control levers to the neutral locked
position and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Remove the nut and bolt position the anti-scalp
rollers and install the nut and bolt. Ensure the
spacers and bushings are installed as shown.
Figure 26
1. Bushing 4. Bolt
2. Anti-scalp roller 5. Nut
3. Spacer
Adjusting the Flow Baffle
The mower discharge flow can be adjusted for different
types of mowing conditions. Position the baffle to give
the best quality of cut.
1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. To adjust the baffle, loosen the nut (Figure 27).
4. Adjust the baffle and nut in the slot to the desired
discharge flow and tighten the nut.
g012676
1 2
Figure 27
1. Slot 2. Nut
Positioning the Flow Baffle
The following figures are only recommendations for
use. Adjustments will vary by grass type, moisture
content, and height of grass.
Note:
If the engine power draws down and the mower
ground speed is the same, open up the baffle.
Position A
This is the full rear position (see Figure 28). The
suggested use for this position is a follows.
• Use for short, light grass mowing conditions.
• Use in dry conditions.
• For smaller grass clippings.
• Propels grass clippings farther away from the
mower.
G012677
Figure 28
24