Adjusting the Flow Baffle
The mower-discharge flow can be adjusted for different types
of mowing conditions. Position the cam lock and baffle to
give the best quality of cut.
1.
Disengage the PTO, move the motion-control levers to
the neutral-locked position, and set the parking brake.
2.
Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3.
To adjust the baffle, loosen the nut (Figure 29).
4.
Adjust the baffle and nut in the slot to the desired
discharge flow and tighten the nut.
g012676
1 2
Figure 29
1.
Slot
2.
Nut
Positioning the Flow Baffle
The following figures are only for recommended use.
Adjustments will vary by grass type, moisture content, and
the height of the grass.
Note:
If the engine power draws down, and the mower
ground speed is the same, open up the baffle.
Position A
This is the full, rear position (see Figure 30). The suggested
use for this position is as follows:
•
In short, light grass mowing conditions
•
In dry conditions
•
Smaller grass clippings
•
Propels grass clippings farther away from the mower
G012677
Figure 30
26
Содержание GrandStand 74568TE
