Operating the Throttle
The throttle control can be moved between
Fast
and
Slow
positions (Figure 12).
Always use the fast position when turning on the mower deck
with the blade-control switch (PTO).
G008946
Figure 12
Operating the Choke
Use the choke to start a cold engine.
1.
If the engine is cold, use the choke to start the engine.
2.
Pull up on the choke knob to engage the choke before
using the ignition switch (Figure 13).
3.
Push down on the choke to disengage the choke after
the engine has started (Figure 13).
G008959
1
2
Figure 13
1.
On position
2.
Off position
Operating the Ignition Switch
1.
Turn the ignition key to the Start position (Figure 14).
When the engines starts, release the key.
Important:
Do not engage starter for more than 5
seconds at a time. If the engine fails to start allow
a 15 second cool-down period between attempts.
Failure to follow these instructions can burn out
the starter motor.
Note:
Additional starting cycles may be required
when starting the engine for the first time after the fuel
system has been without fuel completely.
ST
ART
RUN
ST
OP
G008947
Figure 14
2.
Turn the ignition key to stop to stop the engine.
18
Содержание GrandStand 74568TE
