Toro GrandStand 74553, Руководство оператора

Страница: 45 / 64

6. Loosen the jam nut (Figure 62).
7. Rotate the yoke. To tighten the brake, rotate the
yoke up. To loosen the brake, rotate the yoke down
(Figure 62).
8. Secure the yoke to lower brake lever with the hair pin
cotter pin and clevis pin (Figure 62).
9. Tighten the jam nut (Figure 62).
10. Check the brake operation again; refer to Checking
the Brake.
g013191
1 2
3 4 5
6
1
2
3
4
5 6
Figure 62
1. Jam Nut 4. Hairpin cotter pin
2. Yoke 5. Flat washer
3. Clevis pin 6. Lower brake lever
11. After the brake is adjusted, the lever switch needs
to be checked.
12. Check the gap between the brake lever and the face
of the switch as shown in Figure 63. The gap needs
to be an 1/8 inch (3mm) with the brake
engaged .
13. If needed, loosen the screws holding the switch and
adjust the switch.
g012873
1
5
2
4
3
Figure 63
1. 1/8 inch (3mm) gap
needed between switch
and brake lever 4. Switch button
2. Brake lever 5. Face of the switch
3. Switch
45