G015402
1
2
3
5
4
6
Figure 70
1.
Hydraulic pumps
4.
Clutch retainer
2.
Idler pulley
5.
Pump drive belt
3.
Clutch pulley
6.
Shoulder bolt, nut and
washer connected to
engine deck
6.
Remove the pump drive belt (Figure 70).
7.
Install the new belt around clutch and the two pump
pulleys.
8.
Install the spring onto the shoulder bolt and washer and
connect it to the engine deck with the nut (Figure 70).
9.
Lower the machine to the operating position. Refer to
Pre-Maintenance at the beginning of the Maintenance
Section.
10.
Install the mower deck belt.
Controls System
Maintenance
Adjusting the Motion Control
Handle Positions
Adjusting the Right Side Motion Control
Lever
If the motion control levers do not align horizontally, adjust
the right side motion control lever.
Note:
Adjust the horizontal alignment before the front to
back alignment.
1.
Disengage the PTO, move the right side motion control
lever to the neutral position and set the parking brake.
2.
Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3.
Push the right motion control lever down out of locked
neutral position (Figure 71).
4.
Check if it aligns horizontally with the left motion
control lever (Figure 71).
Figure 71
1.
Left motion control lever
3.
Check the horizontal
alignment here
2.
Right motion control lever
in neutral locked position
4.
Right motion control lever
5.
To adjust the right motion control lever horizontally,
the cam needs to be adjusted.
6.
Release the cushion from the rear of the machine.
7.
Loosen the nut and bolt holding the cam (Figure 72).
8.
Adjust the cam until it aligns with the left motion
control lever and tighten the nut and bolt for the cam.
47
Содержание GrandStand 74549
Страница 64: ...G015606 Electrical Schematic for 48 inch Mower Models Rev A 64 ...
Страница 65: ...g018174 Electrical Schematic for 52 and 60 inch Mower Models Rev A 65 ...
Страница 66: ...Notes 66 ...
Страница 67: ...Notes 67 ...
