Toro GrandStand 74534TE, Руководство оператора

Страница: 32 / 72

Lubrication
Grease with No. 2 general purpose lithium base or
molybdenum base grease.
Lubricate the speed/traction control linkage with a dry
lubricant, PTFE(Polytetrafluoroethylene) (Figure 40).
How to Grease
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Clean the grease fittings with a rag. Make sure to
scrape any paint off the front of the fitting(s).
4. Connect a grease gun to the fitting. Pump grease
into the fittings until grease begins to ooze out of
the bearings.
5. Wipe up any excess grease.
Lubricating the Machine
Service Interval: Every 50 hours—Grease the mower
deck idler arms (more often in dirty
or dusty conditions).
Every 50 hours—Grease the lift
linkage (more often in dirty or dusty
conditions).
Every 50 hours/Yearly (whichever
comes first)—Lubricate the speed
control sliding parts (more often in
dirty or dusty conditions).
Use the following graphics for locating the grease points.
Figure 37
91cm Mower Deck
Figure 38
102cm Mower Deck
Figure 39
Lubricate the speed/traction control linkage with a dry
PTFE (Polytetrafluoroethylene) lubricant.
Important:
Use only a dry PTFE
(Polytetrafluoroethylene) lubricant. Do not
use a wet oil film, which will attract dust and dirt.
32