Toro GrandStand 133-1434, Руководство по установке

Страница: 5 / 8

3. Remove the nuts from the cables.
4. Thread the cables through the rear discharge-chute
bracket (
Figure 7 ).
Note:
Route the cable that is on the left side of the
handle assembly through the left side of the bracket;
route the other cable through the right side.
Figure 7
1. Discharge-chute brackets 2. Pulley
5. Install 1 nut on each cable.
6. Thread the cables through the front bracket and install
the other nuts onto the cable (
Figure 8 ).
Figure 8
1. Nut 3. Slots in pulley
2. The cables are not loose.
7. Slide the ends of the cables into the slots in the pulley
(
Figure 8 ).
8. Adjust the nuts on the cables so that the cables are not
loose between the bracket and pulley (
Figure 8 ).
9. Ensure that the chute door is parallel to the deck and
that the mower blade does not contact it when you
move the chute-control handle to the Closed position;
adjust the cables as necessary.
10. Use the cable ties to secure the cables to the fan guard
and away from moving parts (
Figure 9 ).
Figure 9
Engine not shown in callout bubble
1. Cable tie
5
Installing the Trash Bag
Parts needed for this procedure:
1 Trash bag
Procedure
Install the trash bag into the slots in the handle assembly
(
Figure 10 ).
Figure 10
1. Trash bag 2. Slots in handle assembly
5