Toro Flex-Force Power System 88714, Руководство оператора

Страница: 9 / 20

You may need to rotate the chain-tensioning screw to fit the stud into the slot on the guide bar
(
Figure 14 ).
6. Install the side cover and bar cover screw and loosely tighten the side cover by turning the screw clockwise.
7. Adjust the chain tension; refer to Adjusting the Chain Tension (page 15) .
Connecting the Attachment to the Power Head
1. Install the square shaft of the attachment into the square shaft of the power head (A of Figure 4 ).
2. Align the locking button on the lower shaft with the slotted hole on the upper shaft and slide the 2 shafts
together (B and C of
Figure 4 ).
Note:
The locking button clicks into the slotted hole when the shafts are secured (C of Figure 4 ).
3. Using the screw-handle, tighten the screw on the shaft connector until it is secure (D of Figure 4 ).
g358795
Figure 4
Adding Bar and Chain Oil to the Pole Saw
Important:
Use only bar and chain oil (sold separately).
Fill the pole saw with bar and chain oil before first operation; refer to Checking the Oil Level and Adding
Bar and Chain Oil (page 14) .
9