Toro Flex-Force Power System 51824, Руководство оператора

Страница: 10 / 16

g267488
Figure 9
1. Battery latch
Charging the Battery Pack
Important:
The battery pack is not fully charged
when you purchase it. Before using the tool for
the first time, place the battery pack in the charger
and charge it until the LED display indicates the
battery pack is fully charged. Read all safety
precautions.
Important:
Charge the battery pack only in
temperatures that are within the appropriate
range; refer to
Specifications (page 8) .
Note:
At any time, press the battery-charge-indicator
button on the battery pack to display the current
charge (LED indicators).
1. Ensure that the vents on the battery and charger
are clear of any dust and debris.
g330066
Figure 10
1. Battery pack cavity 5. LED indicators (current
charge)
2. Battery pack venting areas 6. Handle
3. Battery pack terminals 7. Charger
4. Battery-charge-indicator
button
2. Line up the charger with the cavity on the back
of the battery pack (
Figure 10 ).
3. Slide the charger into the battery pack until it is
fully seated (
Figure 10 ).
4. To remove the charger, slide the charger
backward out of the battery.
5. Refer to the following table to interpret the LED
indicator light on the battery charger.
Indicator
light Indicates
Off No battery pack inserted
Green
blinking Battery pack is charging
Green Battery pack is charged
Red
Battery pack and/or battery charger is over or under
the appropriate temperature range
Red
blinking Battery pack charging fault*
*Refer to Troubleshooting (page 12) for more
information.
Important:
The battery can be left on the charger
for short periods between uses.
If the battery will not be used for longer periods,
remove the battery from the charger; refer to
Storage (page 11) .
10