3
Installing the Bagger
Mounting Brackets
Parts needed for this procedure:
1
Upper mounting bracket
1
Lower mounting bracket
4
Carriage bolt (3/8 x 1-1/4 inches)
2
Carriage bolt (1/2 x 2–1/2 inches)
4
Flange nut (large flange–3/8 inch)
2
Flange nut (1/2 inch)
Procedure
Note:
For 60- and 72-inch mowers, do not install
the bolt and flange nut for the left side of the lower
mounting bracket. This will be installed when installing
the handle bracket in the following procedure.
1.
Install the lower mounting bracket to the
machine frame with 4 carriage bolts (3/8 x 1-1/4
inches) and 4 flange nuts (large flange–3/8 inch)
as shown in
.
g017215
Figure 6
1.
Carriage bolt (1/2 x 2-1/2
inches)
4.
Lower mounting bracket
2.
Upper mounting bracket
5.
Carriage bolt (3/8 x 1-1/4
inches)
3.
Flange nut (1/2 inch)
6.
Flange nut (large
flange–3/8 inch)
2.
Install the upper mounting bracket to the left and
right bumpers with 2 carriage bolts (1/2 x 2-1/2
inches) and 2 flange nuts (1/2 inch) as shown
in
4
Installing the Handle
Assembly and Bracket
60- and 72-inch Mowers
Parts needed for this procedure:
1
Handle assembly
1
Handle bracket
4
Carriage bolt (3/8 x 1-1/4 inches)
1
Clevis-pin spring
4
Flange nut (large flange–3/8 inch)
Procedure
1.
Remove the clevis-pin spring from the
bagger-arm assembly (see
2.
Install the handle assembly pin into the handle
bracket and connect them together with a
carriage bolt (3/8 x 1-1/4 inches) and a flange
nut (large flange–3/8 inch).
g009216
Figure 7
1.
Bolt (3/8 x 1-1/4 inches)
4.
Flange nut (large
flange–3/8 inch)
2.
Handle bracket
5.
Assembled handle and
bracket assembly
3.
Handle assembly
11
