Figure 4
1.
Cover
7.
Lower brace
2.
Upper bolts
8.
Corner upports
3.
Front tube
9.
Bottom tube
4.
M5 bolts and nuts
10.
Bag
5.
Left and right supports
11.
Dumping lever
6.
Screws
12.
Rear handle
3. Place the collector on the rear machine supports
(refer to the
Operator’s Manual
) and align the collector
frame with the machine fenders.
4. Tighten the upper bolts (Figure 4).
5. Stretch the bag and put it over the rear handle
6. Insert the bottom tube into the bag (Figure 4).
7. Insert the corner supports under the top tube.
8. Fasten the corner supports to the top and bottom
tubes using the M5 bolts and nuts from under the
collector cover (Figure 4).
9. Fasten the bottom tube to the front tube with M5
bolts and nuts (Figure 4).
10. Tilt the left and right supports rearward.
11. Place the lower brace on the outside of the bag
and secure it to the left and right supports with the
screws (Figure 4).
12. Place the cover on the grass collector.
13. Align the cover with the rear fender by adjusting the
rear machine supports until there is a proper seal
between the cover and the collector.
14. Tighten the rear machine support bolts.
15. Remove the grass collector from the machine.
16. Tighten all screws securely.
17. Use the plastic extrusions on the bag edges to fix
the bag to the frame tube.
18. Insert the dumping lever through the hole of the
cover and secure it with the M5 x 12 screw and M5
nut (inside the tube) (Figure 4).
19. Install the grass collector to the machine (refer to
the
Operator’s Manual
).
20. When the grass collector is properly positioned,
place the arrow decal directly opposite the arrow
symbol on the rear of the machine.
5
Checking the Oil Level
No Parts Required
Procedure
The machine comes from the factory with oil in the
engine crankcase; however, it may be necessary to add
oil. Refer to the
Operator’s Manual
for oil type, viscosity,
and crankcase capacity. Add only enough oil to raise the
level to the Full mark on the dipstick.
6
Activating the Battery
No Parts Required
Procedure
1. Remove the battery from the machine; refer to the
Operator’s Manual
.
2. Remove the filler caps from the top of the battery.
4
Содержание DH 200
Страница 7: ...Notes 7 ...
Страница 8: ......
