background image

4

1.

With vac tube and bag attached, pick up unit by vac tube

handle and housing handle. Bag should be positioned fairly

low at your side. Place bag strap over shoulder and adjust

length to fit.

2.

Turn unit on.

3.

Swing unit slowly back and forth over leaves to be vacuumed.

Do not force tube into pile of debris.

IMPORTANT

w

This unit is designed to pick up and shred dry leaves and

other light, leafy debris.

w

Do not attempt to pick up stones, gravel, broken glass,

twigs, bark, acorns or pine cones  as severe damage to fan

blades may result.

w

Do not pick up anything that is burning or smoking, such

as cigarettes, matches or hot ashes.

w

Do not pick up any liquids, particularly flammable or

combustible liquids such as gasoline, or use in areas where

they may be present.

w

Do not tip vacuum tubes upright and force feed debris into

tubes.

If the unit should start to vibrate or make abnormal noise, stop the

unit, 

unplug

 the cord and check for cause.

Emptying Bag

(Model 51541 Vacuum Kit not included)

1.

Turn unit off. Disconnect extension cord.

2.

Depress both tabs on bag collar to remove bag from unit

(Fig. 12).

3.

Unzip bag and shake out debris.

Maintenance

Clogging

If the unit becomes clogged with debris, the obstruction can

usually be cleared by turning the unit off and then promptly

compressing the bag while it is still inflated, thereby forcing air

back out through the vacuum tubes. This reverse airflow is usually

sufficient to dislodge most obstructions.
If the restriction cannot be cleared by compressing the bag, then

proceed with 

caution

 as follows:

1.

Turn off and 

unplug

 unit.

2.

Remove vacuum tube.

3.

Using a small stick or rod, carefully reach into impeller

opening and clear out debris.

Bag Cleaning

Do not store debris in vacuum bag. Empty bag after each use. After

three uses, clean bag thoroughly. Turn bag inside out and shake out

dust and excess debris vigorously. Once a year, if necessary, wash

the bag by hand in soapy water.

POTENTIAL HAZARD

Under normal usage, the bag material is subject to

deterioration and wear.

WHAT CAN HAPPEN

Small objects could pass through a worn or damaged

bag and be thrown in direction of operator or

bystanders and cause serious personal injury.

HOW TO AVOID THE HAZARD

Check bag frequently for wear or deterioration. If bag

is damaged, replace it with a genuine TORO part.

Impeller Replacement

If a loss of performance is detected while operating blower, unplug

unit, remove inlet cover, and check impeller blades for wear. If

blades are severely worn, see your Authorized TORO Service

Dealer for a new impeller.

Servicing Double-insulated

Appliance

In a double-insulated appliance, two systems of insulation are

provided instead of grounding. No grounding means is provided

on a double-insulated appliance, nor should a means for grounding

be added to the appliance. Servicing a double-insulated appliance

requires extreme care and knowledge of the system, and should be

done only by qualified service personnel. Replacement parts for a

double-insulated appliance must be identical to the parts they

replace. A double-insulated appliance is marked with the words

“DOUBLE INSULATION” or “DOUBLE INSULATED.” The
symbol (square within a square) 

 may also be marked on the

appliance.

Содержание Air Rake 51551













Отзывы: