Toro Air Cool Z Master 74090, Руководство оператора

Страница: 50 / 72

g009195
Figure 55
8. If alignment is needed, loosen the 2
motion-control lever mounting bolts on the
misaligned side (
Figure 56 ).
g254283
Figure 56
9. Move motion-control lever to meet the opposite
side.
10. Tighten the 2 motion-control lever mounting
bolts (
Figure 56 ).
Checking the Tire Pressure
Service Interval: Every 50 hours/Monthly (whichever
comes first)
Drive tires pressure specification: 124 kPa (18 psi).
Note:
The caster tires are semi-pneumatic tires and
do not require air pressure maintenance.
DANGER
Low tire pressure decreases machine side-hill
stability. This could cause a rollover, which
may result in personal injury or death.
Do not under-inflate the tires.
Check the air pressure in the rear tires. Add or remove
air as needed to set the air pressure in the tires to the
tire air pressure specification.
Important:
Maintain pressure in all tires to
ensure a good quality of cut and proper machine
performance.
Check the air pressure in all the tires before
operating the machine.
g001055
Figure 57
Checking the Wheel Lug
Nuts
Service Interval: After the first 100 hours—Check the
wheel lug nuts.
Torque the wheel lug nuts to 115 to 142 N∙m (85 to
105 ft-lb).
50