Toro 824 Power Shift, Руководство оператора, Страница: 15 / 28

15
5. Lift the carburetor heater box up and away from the
engine.
6. Disconnect the green ground wire clip under the throttle
(Fig. 19).
m4947
1
Figure 19
1. Green ground wire clip
7. Install the choke knob.
8. Insert the ignition key.
9. Connect the wire to the spark plug.
Important Use the heater box as a reference for the
choke and throttle positions.
Installing the Carburetor
Heater Box
To install the carburetor heater box, reverse steps 1 through
9 of Removing the Carburetor Heater Box on page 14.
Remove the fasteners from their holes before installing the
carburetor heater box.
Starting the Engine
Important Ensure that there are no obstructions in the
auger/impeller and the discharge chute before you operate
the snowthrower. Use a stick, not your hand, to remove
an obstruction from the auger/impeller or the discharge
chute.
1. Connect the wire to the spark plug.
2. Move the speed shift control to the N (Neutral)
position and the throttle to the Fast position.
3. Release the auger/impeller drive control lever and the
traction control lever (Fig. 13).
4. Open the fuel shutoff valve below the fuel tank
(Fig. 15).
5. Rotate the choke (Fig. 14) to the On position.
6. Insert the ignition key (Fig. 14).
Important Do not use the primer or the choke if the
engine has been running and is hot. Excessive priming may
flood the engine and prevent it from starting.
7. Cover the hole in the center of the primer (Fig. 14) with
your thumb and slowly push in the primer 3 times,
pausing a moment between pushes.
8. Grasp the recoil starter handle (Fig. 17) and pull it out
slowly until positive engagement results; then pull the
handle vigorously to start the engine.
9. Keep a firm grip on the starter handle and return the
rope slowly.
Note: If engine does not start or if the air temperature is
–10
F (–23 C) or colder, the engine may need additional
priming. After pushing in the primer, try to start the engine
before priming again.
10. After the engine starts, immediately rotate the choke
(Fig. 14) to the 3/4 position. As the engine warms up,
rotate the choke to the 1/2 position. When the engine
warms up sufficiently, rotate the choke to the Off
position.
Important Ensure that the auger and impeller do not
rotate while the auger/impeller drive control lever is in the
Disengaged position. Stand in the operating position and
look around to the side of the auger housing (Fig. 20). A
large screw head on the side of the auger housing rotates
when the auger and impeller rotate (Fig. 20). If the auger
and impeller rotate while the engine runs and the
auger/impeller drive control lever is disengaged, stop
the snowthrower immediately. Refer to Adjusting the
Auger/Impeller Drive Belt on page 21. If the problem
persists, take the snowthrower to an Authorized Service
Dealer for service.
m-2680
1
Figure 20
1. Large screw head