Toro 79398, Руководство оператора

Страница: 9 / 20

g028227
Figure 13
1. Machine frame 4. Bolt (5/16 x 1 inch)
2. Locknut (5/16 inch) 5. Pivot frame
3. Hole
3. Secure the pivot frame to the bottom of the
machine frame using 2 self-tapping screws (5/16
x 3/4 inch) as shown in
Figure 14 .
g028174
Figure 14
1. Self-tapping screw (5/16 x
3/4 inch) 2. Pivot frame
4. Attach the drawbar decal 1.3 cm (1/2 inch) to
the left of the attachment mount (
Figure 15 ).
g028305
Figure 15
1. Drawbar decal
5. Install the bent, flared end of a rod into the keyed
slot in the left side of the machine frame, and
move the rod rearward to seat it in the frame
(
Figure 16 ).
Note:
Repeat this step for the right side of the
machine.
g028306
Figure 16
Left side shown
1. Pivot frame hole 4. Support rod
2. Washer 5. Keyed slot, existing
3. Hairpin cotter 6. Bent, flared end of rod
6. Insert the bent ends of the rods into the
attachment mount as shown in
Figure 16 and
secure the end of each rod with a washer and
hairpin cotter.
9