18
Note: Install belt in the outside pulley groove for the
snowthrower.
6. Install the PTO stop back into the clutch (Fig. 28).
7. Install the clutch connector (Fig. 28).
m–5539
1
5
2
4
3
Figure 28
1.
PTO clutch
2.
PTO stop
3.
Snowthrower belt groove
4.
Belt guide
5.
Clutch connector
8. Route belt between belt guide and around idler pulleys
(Fig. 12).
9. Rotate idler bracket to stretch spring and slip belt over
snowthrower pulley (Fig. 12),
m–2788
1
2
3
4
Figure 29
1.
Outer groove of (PTO)
power take off
2.
Idler pulley
3.
Belt guide
4.
Snowthrower pulley
Replacing the Snowthrower Belt on 2000
and Older Models
The following instructions are for 2000 and Older Models
only.
1. Remove the belt cover. Refer to figure 27.
2. Remove hairpin cotters from trunnion and bottom of
yoke (Fig. 30).
3. Unlatch and remove clevis pin that secures yoke
assembly to clutch shaft. Pivot yoke out and forward to
remove from clutch shaft and engagement plate
(Fig. 30).
4. Place belt in outer pulley (Fig. 30).
5. Assemble yoke and engagement plate and attach clevis
pin, trunnion and hairpin cotters to secure (Fig. 30).
m–2691
2
4
1
5
3
7
6
1
Figure 30
1.
Hairpin cotter
2.
Trunnion
3.
Engagement plate
4.
Clevis pin
5.
Yoke
6.
Clutch shaft
7.
Outer groove
6. Route belt between belt guide and around idler pulleys
(Fig. 12).
7. Rotate idler bracket to stretch spring and slip belt over
snowthrower pulley (Fig. 12),
m–2788
1
2
3
4
Figure 31
1.
Outer groove of (PTO)
power take off
2.
Idler pulley
3.
Belt guide
4.
Snowthrower pulley
