Assembly
5
Install Rear and Adjustable
Links
1.
Install rear link to center wheel shaft bracket
with 1/2” washer and 1” cotter pin (Fig. 2).
m–2809
1
2
3
4
5
Figure 2
1.
Rear link
2.
Washer 1/2”
3.
Cotter pin 1”
4.
Attachment lift
5.
Hairpin cotter 2–9/16”
2.
Install both front adjustable links to mower
bracket with (2) 1/2” washers and (2) 1” cotter
pins (Fig. 3).
m–4244
1
2
3
4
5
Figure 3
1.
Adjustable link
2.
Washer 1/2”
3.
Cotter pin 1”
4.
Attachment lift
5.
Hairpin cotter 2–9/16”
Installing the Mower
1.
Park the tractor on a flat surface, disengage the
power take off (PTO), set the parking brake, and
turn the ignition key to “OFF” to stop the
engine. Remove the ignition key.
2.
Turn the front wheels fully to the left and raise
attachment lift lever all the way to the latched
position; refer to tractor Operator’s Manual.
3.
Slide the mower under the chassis from the right
side (Fig. 4) and align rear mounting bushings
with ends of lift arms.
4.
Straighten the front wheels, turn Dial-A-Height
knob counterclockwise, all the way, and lower
the attachment lift lever to the mounting
position; refer to tractor Operator’s Manual.
5.
Place rear guide bushings, first left side then
right, onto lift arms then slide deck left into
position (Fig. 4).
6.
Secure deck to rear lift arms with (2) 3/4”
washers and (2) 3–3/8” hairpin cotters (Fig. 4).
1
4
2
3
5
m–3619
Figure 4
1.
Lift arm
2.
Washer 3/4”
3.
Hair pin cotter 3–3/8”
4.
Rear link
5.
Attachment lift
