Operation
12
Adjusting Dial-A-Height
The Dial-A-Height control (Fig. 17&18) is used to
limit the downward travel of the attachment. The
Dial-A-Height knob is rotated to change the location
of this stop, up or down.
1.
Raise the attachment lift lever: Refer to Raising
Attachments. In the raised, position the
Dial-A-Height knob (Fig. 17&18) can be rotated
to change the stop location. Turn clockwise to
raise and counterclockwise to lower the height of
the attachment.
2.
The Dial-A-Height indicator (Fig. 17&18) will
show the change, high to low, in attachment lift
height as adjustment is made.
Adjusting Anti-Scalp Rollers
The anti-scalp rollers guide the mower over uneven
turf without scalping the lawn. For most cutting
conditions they should be located in the lower hole.
When cutting in 1-1/2” height-of-cut, or lower, move
the anti-scalp rollers to the upper hole position.
1.
Raise the attachment lift lever: Refer to Raising
Attachments.
2.
Remove cotter pin, bolt and shaft to change hole
location (Fig. 19).
3.
Select the hole position for the height-of-cut to
be used and insert rod (Fig. 19).
4.
Secure rod with bolt and cotter pin.
1220
1
2
3
4
5
6
Figure 19
1.
Roller
2.
Cotter pin
3.
Bolt
4.
Rod
5.
Upper hole
6.
Lower hole
