Toro 75744, Руководство оператора

Страница: 43 / 52

g308865
Figure 61
1. Wood block—6.6 cm
(2-5/8 inches) thick 2. Wood block—7.3 cm
(2-7/8 inches) thick
6. Remove the hairpin cotter and washer from the
lower lift-arm pin (
Figure 62 ).
g294197
Figure 62
1. Height-of-cut plate 3. Washer
2. Hairpin cotter
7. Rotate the height-of-cut plate to a different hole
so that it supports the weight of the mower deck
after you install the plate (
Figure 63 ).
g294195
Figure 63
8. Install the washer and hairpin cotter ( Figure 63 ).
9. Repeat steps 6 through 8 for the other side of
the machine.
10. Check the side-to-side level again; repeat this
procedure until the measurements are correct.
11. Continue leveling the mower deck by checking
the front-to-rear blade slope; refer to
Checking
the Front-to-Rear Blade Slope (page 42) .
43