2.
Remove the bolts holding the oil cooler to the engine
housing .
3.
Clean the inside of the oil cooler with a brush.
4.
Install the oil cooler to the engine housing.
G008804
g01301 1
1 2
2
Figure 50
1.
Engine oil cooler
2.
Bolts
Servicing the Spark Plug
Service Interval:
Every 200 hours—Check, clean and regap
the spark plug.
Make sure the air gap between the center and side electrodes
is correct before installing the spark plug. Use a spark plug
wrench for removing and installing the spark plug(s) and a
gapping tool/feeler gauge to check and adjust the air gap.
Install a new spark plug(s) if necessary.
Type :
Champion
®
XC12YC, or equivalent
Air Gap:
0.030 inch (0.76 mm)
Removing the Spark Plug
1.
Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
2.
Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
3.
Remove the lefthand hydraulic unit shroud in the order
listed with Figure 51. This gives you access to the front
spark plug.
Figure 51
1.
Pull this tab out to the
side in the direction of the
arrow
3.
Pull the shroud off of this
frame tab in the direction
of the arrow
2.
Pull the shroud off of this
frame tab in the direction
of the arrow
4.
Shroud
4.
Remove the spark plug.
G008803
Figure 52
5.
Install the lefthand hydraulic unit shroud (Figure 51).
35
