Toro 74926 Z Master G3, Руководство оператора

Страница: 48 / 72

Figure 72
1. Shim
C. Using a pneumatic line, blow out any debris
from under the brake pole and around the brake
spacers.
D. Re-torque each bolt (M6 x 1) to 10 ft-lb (13 N-m)
+/-0.5 ft-lb (0.7 N-m).
E. Using a 0.010 inch thick feeler gauge, verify that
a gap is present between the rotor and armature
face on both sides of the brake pole as shown.
(Due to the way the rotor and armature faces
wear (peaks and valleys) it is sometimes difficult
to measure the true gap.)
Figure 73
1. Feeler gauge
Figure 74
1. Feeler gauge
• If the gap is less than 0.010 inch, then reinstall
the shim and reference the
Troubleshooting
section.
• If the gap is sufficient, proceed to the safety
check in step F.
F. Perform the following safety check:
a. Sit on the seat and start the engine.
b. Make sure the blades Do Not engage with the
PTO switch “off ” and the clutch disengaged.
If the clutch does not disengage, reinstall the
shim and reference the
Troubleshooting
section.
c. Engage and disengage the PTO switch
ten consecutive times to ensure the clutch
is functioning properly. If the clutch
does not engage properly, reference the
Troubleshooting section.
48