Toro 74923 Z Master 6000, Руководство оператора

Страница: 58 / 68

10. Fine-tune the adjustment nut on the front deck lift
assembly by turning it (
Figure 91 ).
Note:
To increase the height, turn the adjustment nut
clockwise; to decrease, turn counterclockwise.
Note:
If the front deck links do not have enough
adjustment to achieve accurate cut height, the
single-point adjustment can be utilized to gain more
adjustment.
g027344
1
2
2 1
3 4
Figure 91
1. Adjustment nut 3. Rear deck adjustment
2. Jam nut 4. Front deck adjustment
11. To adjust the single-point system, loosen the 2 bolts at
the bottom of the height-of-cut plate (
Figure 92 ).
Figure 92
1. Bolts at the bottom of the height-of-cut plate
12. If the deck is too low, tighten the
single-point-adjustment bolt by rotating it clockwise. If
the deck is too high, loosen the single-point-adjustment
bolt by rotating it counterclockwise (
Figure 93 ).
Note:
Loosen or tighten the single-point adjustment
bolt enough to move the height-of-cut plate mounting
bolts at least 1/3 the length of the available travel in
their slots. This regains some up and down adjustment
on each of the 4 deck links.
g017036
Figure 93
1. Single-point adjustment bolt
13. Tighten the 2 bolts at the bottom of the height-of-cut
plate (
Figure 92 ). T
Note:
In most conditions, the back blade tip should
be adjusted 6.4 mm (1/4 inch) higher than the front.
14. Torque the 2 bolts to 37 to 45 N∙m (27 to 33 ft-lb).
58