Premaintenance
Procedures
Raising the Seat
Make sure the motion control levers are locked in the neutral
lock position. Lift the seat forward.
The following components can be accessed by raising the seat:
•
Service decal
•
Fuses
•
Battery and cables
Lubrication
Greasing the Bearings
Service Interval:
Every 25 hours—Grease all lubrication
points.
Grease Type:
No. 2 General Purpose Lithium Base Grease
1.
Park the machine on a level surface and disengage the
blade control switch.
2.
Move the motion control levers outward to the neutral
lock position, stop the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3.
Clean the grease fittings (Figure 41 and Figure 40) with
a rag. Make sure to scrape any paint off of the front
of the fitting(s).
G009949
1
Figure 41
1.
Front caster tire
4.
Connect a grease gun to each fitting (Figure 40 and
Figure 41). Pump grease into the fittings until grease
begins to ooze out of the bearings.
5.
Wipe up any excess grease.
33
Содержание 74920 TITAN ZX4820
