5
Servicing the Engine
No Parts Required
Procedure
Engine is shipped with oil; check oil level and if
necessary fill to the appropriate level with oil as specified
in Engine Owner’s Manual.
6
Servicing the Hydraulic Oil
No Parts Required
Procedure
The machine is shipped with hydraulic oil. Verify level
on Expansion Tank (see Figure 5).
1. Start engine and drive the machine forward and
backward for a few minutes to allow any extra air to
purge out of the hydraulic system.
2. Stop engine and wait for all moving parts to stop.
Remove key and engage parking brake.
3. Check expansion tank and if necessary add MOBIL 1
15W-50 synthetic motor oil to the FULL COLD line.
Note:
The proper amount of oil should have been
added at the factory. If the reservoir is slightly over
full, Do Not remove fluid. The level will go down
once all of the air is purged from the system.
Figure 5
1.
Engine
2.
Expansion tank
4. Replace expansion tank cap and tighten until snug.
Do Not overtighten.
7
Installing the Discharge
Deflector
Parts needed for this procedure:
1
Deflector assembly
1
Rod
1
Spring
1
Cotter pin
Procedure
1. Install discharge deflector (Figure 6).
4
