Toro 74710 TimeCutter SS 3225, Руководство оператора

Страница: 18 / 48

WARNING
The machine can spin very rapidly. The operator
may lose control of the machine and cause personal
injury or damage to the machine.
• Use caution when making turns.
• Slow the machine down before making sharp
turns.
The throttle control regulates the engine speed as measured
in rpm (revolutions per minute). Placing the throttle control
in the Fast position can be best for performance. For most
applications, operating in the full-throttle position is desirable.
Figure 15
1. Park (brake) position 4. Backward
2. Center, unlock position 5. Front of the machine
3. Forward
Using the Smart Speed TM Control
System
The Smart Speed
TM
Control-System lever, located below the
operating position ( Figure 16 ), gives the operator a choice
to drive the machine at 3 ground speed ranges—trim, tow,
and mow.
Figure 16
1. Smart speed lever
To change speeds, do the following:
1. Move the motion control levers to neutral and outward
to the park position.
2. Disengage the blade control switch
3. Adjust the lever to the desired position.
The following are only recommendations for use.
Adjustments will vary by grass type, moisture content, and
the height of the grass.
Suggested
uses:
Trim Tow Mow
Parking X
Heavy, wet
grass X
Training X
Bagging X
Mulching X
Normal
mowing X
Transport X
Trim
This is the lowest speed. The suggested uses for this speed
are as follows:
•
Parking
•
Heavy, wet grass mowing conditions
•
Training
Tow
This is the medium speed. The suggested uses for this speed
are as follows:
18