Toro 74596, Руководство оператора

Страница: 29 / 40

Servicing the Grass
Collector
Removing the Grass Collector
1. Lock the locking latch on the grass collector (Figure 39).
G017881
1
2
Figure 39
2. Lift up the collector using the top support bar.
Installing the Grass Collector
1. Hang the top support bar onto the 2 notches in the
support bracket at the rear of the machine (Figure 40).
1
2
G012467
Figure 40
1. Top support bar 2. Notches in collector
support bracket
Note:
Ensure that the grass collector is properly
seated on the mower. The mower will not function
unless the grass collector is properly attached.
2. Unlock the locking pin to allow for emptying the grass
collector.
Cleaning the Grass Collector
and Tunnel
1. Disengage the blades (PTO).
2. Set the parking brake.
3. Stop the engine and wait for all moving parts to stop.
4. Remove the ignition key.
5. Remove the grass collector; refer to Removing the
Grass Collector.
6. Clean the collector bag with pressurized water.
7. Wipe the area around the full-bag sensor.
8. Clean the inside of the discharge tunnel all the way to
the mower.
9. Install the grass collector; refer to Installing the Grass
Collector.
Note:
Allow the bag to dry thoroughly before
installing it.
29