Toro 74560, Руководство оператора

Страница: 21 / 40

2. Pull up on the air cleaner cover handle and rotate it
toward the engine (Figure 22).
G012454
1
2
Figure 22
1. Air cleaner cover 2. Air cleaner cover handle
3. Remove the air cleaner cover.
4. Carefully slide the paper element and the foam element
from the blower housing (Figure 23).
1
2
3
4
5
G012455
Figure 23
1. Paper element 4. Tab
2. Foam element 5. Slot
3. Air cleaner cover
Cleaning the Foam and Paper Elements
Foam Element
1. Wash the foam element in liquid soap and warm water
and rinse it thoroughly.
2. Dry the element by squeezing it in a clean cloth.
Note:
Do not oil the foam element.
Important:
Replace the foam element if it is torn or
worn.
Paper Element
1. Lightly tap the paper element on a flat surface to
remove dust and dirt.
2. Inspect the element for tears, an oily film, and damage
to the rubber seal.
Important:
Never clean the paper element with
pressurized air or liquids, such as solvents, gasoline, or
kerosene. Replace the paper element if it is damaged or
cannot be cleaned thoroughly.
Installing the Foam and Paper Elements
Important:
To prevent engine damage, always operate
the engine with the complete foam and paper air cleaner
assembly installed.
1. Place the foam element and paper element into the
blower housing.
Note:
Ensure that the rubber seal is flat against the
air cleaner base.
2. Align the tabs on the air cleaner cover with the slots of
the blower housing (Figure 23). Hook the handle onto
the cover and press down on the handle to lock the
cover in place.
Servicing the Engine Oil
Oil Type: Detergent oil (API service SF, SG, SH, SJ, or higher)
Crankcase capacity: 48 oz. or (1.4 l) with filter; 44 oz. or (1.3
l) without filter
Viscosity: See the oil table (Figure 24).
Figure 24
Checking the Engine Oil Level
Service Interval: Before each use or daily
1. Park the machine on a level surface.
2. Disengage the blades (PTO).
3. Set the parking brake.
4. Stop the engine and wait for all moving parts to stop.
5. Remove the ignition key.
6. Open the hood.
7. Clean around the dipstick (Figure 25) so that dirt
cannot fall into the filler hole and damage the engine.
21