Toro 74560, Руководство оператора

Страница: 16 / 40

CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition and KeyChoice keys
and set the parking brake when leaving the machine
unattended, even if it is just for a few minutes.
Emptying the Grass Collector
When the grass collector is full, a buzzer sounds, and the
grass collector must then be emptied.
Important:
To prevent the discharge tunnel from
getting clogged, disengage the blades (PTO) when the
buzzer sounds.
1. If the locking pin is in the locked position, unlock it
(Figure 16).
1
G012470
2
Figure 16
1. Top support bar 2. Locking pin
2. Disengage the blades (PTO) and move the throttle to
the Slow position.
3. Pull the grass collector dump lever forward to tilt the
grass collector (Figure 17).
G012451
1
2
Figure 17
1. Pull the grass collector dump lever forward to empty the
grass.
4. Empty the grass collector.
5. Before returning the grass collector to the operating
position, move the machine forward to clear the grass
collector of the deposited grass.
6. Slowly lower the dump lever to return the grass
collector to the operating position.
Mulching the Grass
To mulch the grass clippings, you must install a mulch plug in
the machine.
1. Disengage the blades (PTO).
2. Set the parking brake.
3. Stop the engine and wait for all moving parts to stop.
4. Remove the grass collector; refer to Removing the
Grass Collector.
5. Insert the mulch plug (Figure 18) into the discharge
opening at the rear of the machine, and hook it into the
hole in the discharge chute(Figure 19).
Figure 18
1. Mulch plug
16