Toro 74560, Руководство оператора

Страница: 14 / 40

Figure 13
1. KeyChoice switch
DANGER
You could back over a child or bystander while the
mower blades or other attachment is engaged and
cause serious injury or death.
• Do not mow in reverse unless it is absolutely
necessary.
• Do not insert the KeyChoice key unless it is
absolutely necessary.
• Always look backward and down before backing
up the machine.
• Use the KeyChoice switch only if you are certain
that no children or other bystanders will enter
the mowing area.
• Be very observant after deactivating the interlock
because the sound of the engine may prevent
you from noticing that a child or bystander has
entered the work area.
• Always remove both the ignition and KeyChoice
keys and put them in a safe place out of the
reach of children or unauthorized users when
you leave the machine unattended.
1. Engage the blades (PTO).
2. Insert the KeyChoice key into the switch (Figure 13).
3. Turn the KeyChoice key.
A red light on the front console (Figure 5) turns on,
indicating that the interlock is disabled.
4. Operate the machine in reverse and complete your task.
5. Disengage the blades (PTO) to activate the interlock.
6. Remove the KeyChoice key and put it in a safe place
out of the reach of children.
Testing the Safety Interlock
System
CAUTION
If the safety interlock switches are disconnected or
damaged, the machine could operate unexpectedly,
causing personal injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock switches
daily and replace any damaged switches before
operating the machine.
Test the safety interlock system before you use the machine
each time. If the safety interlock system does not operate as
described below, have an Authorized Service Dealer repair the
safety interlock system immediately. While sitting in the seat,
perform the following checks:
1. Set the parking brake, shift the blade control (PTO)
knob to the Engage position, and turn the ignition key
to Start: The engine should not crank.
2. Shift the blade control (PTO) knob to the Disengage
position, release the parking brake, and turn the ignition
key to Start: The engine should not crank.
3. Set the parking brake, shift the blade control (PTO)
knob to Disengage, and start the engine. While the
engine is running, release the parking brake and rise
slightly from the seat: The engine should stop.
4. Shift the blade control (PTO) knob into the Disengage
position, put the traction control pedal in Neutral, and
start the engine. While the engine is running, shift the
blade control (PTO) knob into the Engage position
and put the traction control pedal in Reverse: The
engine should stop.
5. Shift the blade control (PTO) knob into the Disengage
position and put the traction control pedal in Neutral.
Start the engine, shift the blade control (PTO) knob
into the Engage position, and turn the KeyChoice key
and release it: The operating-in-reverse warning light
should illuminate.
6. Shift the blade control (PTO) knob to the Disengage
position: The operating-in-reverse warning light should
turn off.
Pushing the Machine Manually
Important:
Always push the machine manually. Never
tow the machine because it may damage the transaxle.
To Push the Machine
1. Park the machine on a level surface.
14