G015501
1
2
3
4
Figure 89
60 inch mower decks
1.
Adjustment rods
3.
Lift link
2.
Rear nuts
4.
Front nuts
Matching Height of Cut
1. Check the rear tire pressure.
2. Set the height-of-cut to the 3 inch (7.6 cm) position.
Refer to Adjusting the Height-Of-Cut in Operation.
3. With the machine on level surface, position one blade
front-to-rear. Measure at
A
and from level surface to
the cutting edge of the blade tips (Figure 90).
Figure 90
1.
Measure from a level
surface
2.
Measure blade at point
A
4. The measurement should be 3 inch (7.6 cm).
5. If it does not measure correctly, locate the
height-of-cut rod on the right side of the machine
(Figure 91).
6. Adjust the adjustment bolt until the blade tips match
3 inches (7.6 cm) (Figure 91).
g015336
1
2
Figure 91
1.
Height-of-cut rod
2.
Adjustment bolt
Replacing the Grass Deflector
WARNING
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator’s or
bystander’s direction and result in serious injury.
Also, contact with the blade could occur.
Never operate the lawn mower unless you install a
cover plate, a mulch plate, grass deflector or bagger.
57
Содержание 74538
Страница 62: ...Schematics Hydraulic Schematic Rev A 62 ...
Страница 63: ...G015606 Electrical Schematic Rev A 63 ...
