Toro 74272CP, Руководство оператора

Страница: 23 / 64

Figure 18
1. Outer roller 4. Bolt
2. Spacer
5. Nut
3. Bushing
4. Select a hole so that the outer roller is
positioned to the nearest corresponding
height-of-cut desired (Figure 18).
5. Install the outer roller, bushing, spacer, bolt,
and nut (Figure 18).
6. Torque the bolt to 40 to 45 ft-lb (54 to 61
N
⋅
m).
Adjusting the Center Rollers
1. Disengage the PTO, move the motion control
levers to the neutral locked position, and set
the parking brake.
2. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3. After adjusting the height-of-cut, remove the
flange nut, bushing, and bolt (Figure 19).
Figure 19
1. Outer roller 4. Bolt
2. Spacer 5. Nut
3. Bushing
4. Select a hole so that the center rollers are
positioned to the nearest corresponding
height-of-cut desired (Figure 19).
Note:
Do not adjust the rollers to support
the mower housing.
5. Install the center rollers, bushing, spacer, bolt,
and nut (Figure 19).
6. Torque the bolt to 40 to 45 ft-lb (54 to 61
N
⋅
m).
Adjusting the Flow Bafe
The mower discharge flow can be adjusted for
different types of mowing conditions. Position the
cam locks and baffle to give the best quality of cut.
1. Disengage the PTO, move the motion control
levers to the neutral locked position and set
the parking brake.
2. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3. To adjust the cam locks, swing the lever up to
loosen the cam lock (Figure 20).
4. Adjust the baffle and cam locks in the slots to
the desired discharge flow.
5. Swing the lever back over to tighten the baffle
and cam locks (Figure 20).
6. If the cams do not lock the baffle into place or
it is too tight, loosen the lever and then rotate
23