Toro 74259, Руководство оператора, Страница: 20 / 60

20
8
Step
No parts needed for this step.
Checking the Hydraulic Fluid
Check the hydraulic fluid level before the engine is first
started.
Refer to Checking the Hydraulic Fluid on page 42.
9
Step
No parts needed for this step.
Greasing the Bearings
Make sure cutting unit spindles are full of grease
before engine is first started.
Grease with No. 2 general purpose lithium base or
molybdenum base grease.
1. Grease the fittings on the three spindle bearings.
Grease until it comes out lower seals (Fig. 8).
1
M–5036
Figure 8
1. Spindles
10
Step
No parts needed for this step.
Checking the Side Discharge
Chute
Remove plastic tie holding side discharge chute up and
lower into place.
11
Step
No parts needed for this step.
Checking the Level of the
Mower Deck
Check the level of the deck before the machine is first put
in use.
Refer to Mower Leveling and Compression Spring
Adjustment in the Maintenance section on page 49.