9.
Slowly fill the reserve tank until level reaches the
bottom of the filler neck.
Do not overfill.
Install the
reserve tank cap.
10.
Start the engine and operate it until warm.
11.
Stop the engine. Check the coolant level and replenish
it, if required.
Brake Maintenance
Adjusting the Parking Brake
Service Interval:
After the first 10 hours
Every 200 hours
1.
Remove the rubber grip from the parking brake lever
(Figure 54).
Figure 54
1.
Parking brake lever
2.
Grip
2.
Loosen the set screw securing the knob to the parking
brake lever (Figure 55).
3.
Rotate the knob until a force of 200 to 222 N (45 to 50
lb) is required to actuate the lever.
Figure 55
1.
Parking brake lever
3.
Set screw
2.
Knob
4.
Tighten the set screw when finished.
Note:
If no adjustment is left at the handle, loosen the
handle to the middle of the adjustment and adjust the
cable at the rear, then repeat step 3.
5.
Install the rubber grip onto the parking brake lever.
43
Содержание 7379
