Toro 68138, Руководство оператора, Страница: 21 / 41

g028106
Figure 19
1. Air-cleaner cover 3. Paper element
2. Foam element
Servicing the Foam Element
1. Wash the foam element in warm water and
detergent.
2. Rinse and allow it to air dry.
3. Lightly oil the foam element with new oil and
squeeze out excess oil.
Servicing the Paper Element
1. Gently tap the paper element to dislodge dirt.
Note:
Do not wash the paper element or use
pressurized air, as this damages the element.
Note:
Replace a dirty, bent, or damaged
element. Handle the new element carefully;
do not use if the sealing surfaces are bent or
damaged.
2. Clean the air-cleaner base as required, and
check the condition.
Installing the Elements
1. Install the foam element onto the paper element.
2. Install the elements onto the air-cleaner base
(
Figure 19 ).
3. Install the cover, and secure it with the latches
(
Figure 18 ).
Checking the Engine-Oil
Level
Service Interval: Before each use or daily
Important:
Remember to add 80% of the oil,
and then gradually fill it to the Full mark on the
dipstick.
Important:
Do not run the engine with the oil
level above the Full mark or below the low mark.
Otherwise, you may damage the engine.
1. Park the machine on a level surface, move
the motion-control levers to the N
EUTRAL
-
LOCK
position, engage the parking brake, and lower
the hopper.
2. Shut off the engine, and remove the key. Allow
the engine to cool.
3. Open the cowl.
4. Check the engine-oil level as shown in Figure
20 .
g243578
Figure 20
20
Go
to
Discount-Equipment.com
to
order
your
parts