Product Overview
Figure 5
1.
Water tank
4.
Handle
2.
Engine
5.
Belt cover
3.
Air filter
6.
Lifting handles
Figure 6
1.
Recoil starter
4.
Choke lever
2.
Sediment cup
5.
Throttle lever
3.
Fuel shut-off valve
6.
Engine On/Off switch
Operation
Note:
Determine the left and right sides of the machine
from the normal operating position.
Checking the Engine Oil Level
Service Interval:
Before each use or daily
1.
Stop the machine on a level surface.
2.
Set the throttle to slow, turn off the engine switch, and
wait for all moving parts to stop.
3.
Clean around the dipstick (Figure 7) so that dirt cannot
fall into the filler hole and damage the engine.
1
Figure 7
1.
Dipstick
4.
Unscrew the dipstick and wipe the end clean (Figure 7).
5.
Screw the dipstick fully onto the filler tube (Figure 7).
6.
Unscrew the dipstick again and look at the end. If the
engine oil level is low, slowly pour only enough oil into
the filler tube to raise the level to the Full mark on the
dipstick.
Important:
Do not overfill the crankcase with
engine oil and run the engine; engine damage
may result.
Cleaning Debris from the
Machine
Service Interval:
Before each use or daily
1.
Set the throttle to slow, stop the engine, and wait for
all moving parts to stop.
WARNING
Contact with hot parts on the machine can
cause severe burns.
Wait for all parts to cool before touching the
machine.
2.
Brush dirt and debris away from the air cleaner and
engine openings.
3.
Check the sprinkler tube and remove any dirt or debris.
7
Go
to
Discount-Equipment.com
to
order
your
parts
